Beginner's Technology

eBGPの設定(10)

• ikepon
• 2005年10月09日
• コメントする
• トラックバック (2)
• カテゴリー:Zebra

次の様にして、show ip bgp neighborコマンドで接続先の確認します。
external linkとなっていればeBGPとなっているので成功です。

bgpdA# show ip bgp neighbor 192.168.10.101
BGP neighbor is 192.168.10.101, remote AS 2, local AS 1, external link
  BGP version 4, remote router ID 192.168.20.100
  BGP state = Established, up for 00:04:12
  Last read 00:00:12, hold time is 180, keepalive interval is 60 seconds
  Neighbor capabilities:
    Route refresh: advertised and received(old & new)
    Address family IPv4 Unicast: advertised and received
  Message statistics:
    Inq depth is 0
    Outq depth is 0
                         Sent       Rcvd
    Opens:                  2          1
    Notifications:          1          0
    Updates:                0          0
    Keepalives:            33         31
    Route Refresh:          0          0
    Capability:             0          0
    Total:                 36         32
  Minimum time between advertisement runs is 30 seconds

 For address family: IPv4 Unicast
  Configuration flags 0x0
  Community attribute sent to this neighbor(both)
  0 accepted prefixes

  Connections established 2; dropped 1
  Last reset 00:04:18, due to User reset
Local host: 192.168.10.100, Local port: 53795
Foreign host: 192.168.10.101, Foreign port: 179
Nexthop: 192.168.10.100
Nexthop global: fe80::20c:29ff:feb5:bd6c
Nexthop local: ::
BGP connection: non shared network
Read thread: on  Write thread: off