Beginner's Technology

インターフェース起動(4)

• ikepon
• 2005年12月21日
• コメントする
• トラックバック (58)
• カテゴリー:Foundry

イネーブルモードに戻ってインターフェースの状態を確認すると、インターフェースがアップしています。

telnet@L2foundry(config-if-e1000-1)#^Z
telnet@L2foundry(config-if-e1000-1)#^Z
telnet@L2foundry#show interface ethernet 1
GigabitEthernet1 is up
  Hardware is GigabitEthernet, address is 000c.db95.6d48 (bia 000c.db95.6d48)
  Configured speed 1Gbit, actual 100Mbit, configured duplex fdx, actual fdx
  Configured mdi mode AUTO, actual MDI
  Member of L2 VLAN ID 100, port is untagged, port state is FORWARDING
  STP configured to ON, priority is level0, flow control enabled
  mirror disabled, monitor disabled
  Not member of any active trunks
  Not member of any configured trunks
  No port name
  MTU 1500 bytes
  300 second input rate: 56 bits/sec, 0 packets/sec, 0.00% utilization
  300 second output rate: 56 bits/sec, 0 packets/sec, 0.00% utilization
  929 packets input, 74052 bytes, 0 no buffer
  Received 179 broadcasts, 45 multicasts, 703 unicasts
  0 input errors, 0 CRC, 0 frame, 0 ignored
  0 runts, 0 giants, DMA received 929 packets
  1791 packets output, 129103 bytes, 0 underruns
  Transmitted 70 broadcasts, 833 multicasts, 888 unicasts
  0 output errors, 0 collisions, DMA transmitted 1791 packets